Thread
:
Draw bar tightening torque....
View Single Post
#
6
Posted to rec.crafts.metalworking
Terry Coombs
external usenet poster
Posts: 364
Draw bar tightening torque....
wrote:
What is the spindle taper and what is the tooling in the spindle ?
MT3. End mill holder and drill chuck tapers. No collets.
Then I'd suggest it just needs to be tight enough to seat the taper . Get
out the torque wrench and do a few tests ... I know that a drill chuck in
the 3MT tailstock on my lathe will take quite a bit of torque , with no
drawbar at all . Just slid in firmly by hand .
--
Snag
every answer
leads to another
question
Reply With Quote
Terry Coombs
View Public Profile
Find all posts by Terry Coombs