"Dave Plowman (News)" wrote in message
...
In article ,
Tim Wescott wrote:
Start harvesting the snap-on battery cords from dead electronics. Cut
the wires off short (preferably inside the vinyl housing a bit). Snap
them on -- there you are!

Most of those break after a few operations.

You could take a dead battery apart and use the connector block from that
after insulating. Usually far stronger than the wire ended connectors.


That would be my suggestion, you could insulate the terminal rivets with
blobs of epoxy glue or with some makes of battery the blank plastic insert
from the bottom could be superglued on for insulation.