Electrolytics question
Tom Del Rosso wrote:
"Eeyore" wrote in message
f825_677 wrote:
You should try a Sony 1602 or 1601 IC from one of their broadcast
mixer boards - it can take an hour if you're lucky and all day if
you're not and we have professionaly desoldering vacumme equipment
- the holes are barely larger than the pin its self every engineer
working on these things in every broadcast engineering department
complaints about these devices.. Give me a 100 pin BGA device any
day..
If you know the IC's buggered (or even of low commercial value), cut
every pin and remove them individually. Then clean the holes up. It
always wins on time and cost.
Isn't that a PGA? Hard to cut the pins.
Yes it is - and you're right.
|