troye wrote:
My generator head cooked and I would like to use the engine for a new
setup however the engine has a tapered shaft and the new generator
head takes a belt pulley instead of a direct hookup, where can i
obtain a pulley that will fit a tapered shaft.thanks
The first step would be to measure your shaft to know taper ratio, big and small end
diameters. I'm used to snowmobiles, those things used a 1:10 taper iirc, can't remember
nominal diameter.
I did a google, Amazon sells a Briggs with a tapered shaft.
http://www.amazon.com/Briggs-Tapered.../dp/B0000AXF2P
I tried to figure out what taper is used but wasn't successful.
Once you know what you have, I'd check browning.
Wes