Eeyore wrote:
This is a well established technique for preventing voice coils burning
out under conditions of 'overdrive'.

There is a stage monitor I'm having problems with that uses this method.

The HF sounds very distorted and almost cuts in and out.

I looked closely inside and found some damaged push-on terminals. Ah, I
thought, probably a poor contact causing the probelm, replaced them,
checked driver DC resistances etc, reassembled thinking I'd probably
fixed it.

But no, the low level HF and distortion continued.

I'd checked the DC resistance of the protection bulb but later it
occurred to me that it might have 'very nearly' burnt out and have a
weak spot that wouldn't show up on a DVM but passing signal would heat
it and cause this trouble. I'll be able to find out soon enough but I
wondered if anyone else had ever encountered this ?

In the meantime I brought the HF driver home to check it's not voice
coil rub.


Some Machs and RCFs use a 24 volt projector lamp. I`ve seen these become
intermittent - they check fine with a meter, but introduce terrible
distortion and crackling under pressure - it sounds just like the driver
diaphragm breaking up. They also easily break if the cabinet is roughly
handled.


Ron