On Fri, 14 Nov 2008 17:54:00 -0800, "Michael Koblic"
wrote:


"Harold and Susan Vordos" wrote in message
.net...

Did I mention you should not use end mills to drill holes? :-)


OK, I won't. In any case, there was not a 5/32 mill in the whole of Campbell
River today, so I could not even try this heinous crime :-)
Thanks,
My first end mill was a highly modified, very short 3/8" drill bit
used in my unimat 3 milling setup to balance a die cast disk sander
disk.
Gerry :-)}
London, Canada