Spin it at ~600 rpm though a belt?

Jim Wilkins wrote:
On Nov 12, 11:27 am, Mechanical Magic
wrote:
Try hehttp://baileynet.com/index.php?id=31...tegory=1000008
"GC Series" looks very close @ .5 gpm 1800 rpm,cast.

http://www.northerntool.com/webapp/w...roduct_6970_20...

Dave J.

On Nov 12, 7:39 am, RoyJ wrote:
My latest research project needs a small hydraulic pump, quite a bit
smaller than a standard pump. Plan to drive it with a VFD/3phase motor.
I'd like to get it running by next week so cheap and fast are the
buzzwords....

Those would be my choices too. Note that not all pumps have bearings
capable of pulley side loads, you need a pressure relief somewhere,
and SAE Spline shafts are hard to connect to, I had to mill a broach.
Keyed shafts and Lovejoy L095 couplers work well.