"Tom Veatch" wrote in message
...
On Fri, 24 Oct 2008 17:03:39 -0600, Chris Friesen
wrote:

Leon wrote:

Apparently it will not cut a 2x4 in to 2 pieces.

How do you figure that? Depth of cut is a bit over 2" when using the
track.
Even when beveled at 45 degrees it can still do better than 1.5", so a 2x4
should be no problem.

Chris

Description says 2 1/8 depth of cut. Assuming that's square/90° it
wouldn't have any problems with a 2x4 nominal 1.5x3.5 actual. But it
would be real close at 45°. Calculated cut depth = 1.503

Tom Veatch
Wichita, KS
USA

My mistake Tom, You are absolutely correct. What was I thinking?