Thread
:
what are "female reducers" used for?
View Single Post
#
2
Posted to alt.home.repair
The Daring Dufas[_4_]
external usenet poster
Posts: 63
what are "female reducers" used for?
wrote:
This part was in a catalog of rigid conduit fittings. It is just like
a reducing bushing, threaded inside and out, but it
also has a "hex nut" flange one one end so it can be turned with a
wrench. What are these normally used for?
Another clue-- the part is a Thomas & Betts 1250. Could this be
used to enter a box that has a knockout that's
a size too big?
--zeb
If this is what you're talking about,
http://www.tnb.com/ps/fulltilt/index.cgi?part=1250TB
You would use it to attach 1/2" conduit or a fitting
to a cast "Malleable Iron" box or condulet that has
3/4" threaded hole. You would screw the 3/4" part
into the box or condulet using the hex flange to
tighten it with a wrench. You would then screw your
1/2" conduit or fitting into internal part of the
adapter.
TDD
Reply With Quote
The Daring Dufas[_4_]
View Public Profile
Find all posts by The Daring Dufas[_4_]