On Oct 8, 6:01�pm, "RBM" wrote:
"TKM" wrote in message

...







"RBM" wrote in message
...

"scrapwood" wrote in message
.. .
I have a question that I can't seem to find an answer to.

The task is adding a new sub-panel in an outbuilding. �I understand that
new sub-panels now require a 4-wire feeder line, however this feeder
will
be coming from the service disconnect. �Specifically, it will be coming
from a small lug box on the side of the service disconnect; because this
is how the existing outbuildings are being fed.

So, my quesiton is: Is the fourth wire required in this situation,
coming
off the disconnect. �If it is required, what is it connected to??

Thanks in advance for any advice!
scrapwood.

-----------------------------------

##-----------------------------------------------##
Delivered via �http://www.thestuccocompany.com/
Building Construction and Maintenance Forum
Web and RSS access to your favorite newsgroup -
alt.home.repair - 317306 messages and counting!
##-----------------------------------------------##

I'm not completely sure I understand your situation, however, if this
feeder to the outbuilding is connected to the "load" side of the service
disconnect, it will require four wires for a 120/240 volt feeder. Two hot
legs, one neutral, and one ground. You may have to drive additional
ground rods at the outbuilding as well

The ground line can be bare and is sometimes wrapped around the others to
make a sturdy cable.

That is not the ground. It is the neutral conductor of an "SEU" type cable



But there's another possibility if you have heavy motor loads. �What you
heard could apply to a 3-phase system and, specifically, a 3-phase "Y"
system which has 4 wires.

Even if the OP had a 3 phase wye service, it would still require a fifth
conductor as it would require three hot legs, one neutral, and one ground





TKM- Hide quoted text -

- Show quoted text -- Hide quoted text -

- Show quoted text -

or run a empty conduit for a future use. cheap choice