thats a good idea,,, I take a look and see how much play there is.... I
hadn't thought about that... even 1/4 inch might give me a chance to pull
the gear!!

If I can get the gear off, then machining it gets a whole lot simpler...

bob in phx.
"Wes" wrote in message
...
"Bob in Phx" wrote:

the motor has a 150 degree shutoff so, it shouldn't get that hot....

I doubt you will get clearance to get glue in, shaft and gear both with
expand.

The bearing looks like it is held in by 3 screws, if you take them out can
you fully
expose bearing? by pushing case backwards?

If you can cut the od of bearing off you can get purchase on gear to pull
it.

Wes