Best way to drill through cast iron???
Drill cast iron dry. Hand drill would work just fine.
"Edwin Pawlowski" wrote in message
m...
tnfkajs wrote:
If I wanted to attach some brackets to the table saw cast iron top, I
think
I'd be drilling some biggun holes into some purdy thick iron. Would I
be an
idiot to try this? Would it take forever?
If there is a flat surface, you can atach a magnetic drill. Good tool
rental shops have them, but it will probably be $50 for the day. You
supply
the bit. Yes, lube as you drill, even if it is only a spray of WD-40.
Or - should I dimiss this approach and look for another way to attach
the
outfeed table?
Anything you can clamp on to?
Ed
|