Good suggestions so far. Grassyass. The original gear is nylon. I
replaced the Nema17 stepper in the application with a much more
powerful N17 double stack motor. I ground the flat onto the new
motor's shaft, to match the original, then determined the nylon hub
will not take the torque. Thus, new gear.
JR
Dweller in the cellar

On Mon, 08 Sep 2008 10:37:12 -0700, JR North
wrote:

Have a project, need a gear for a stepper with .187" Dia D shaft. I can
make the gear; are there broaches for forming the pilot bore? Seems
there would be a bazillion different ones, depending on the width of the
flat.
Else, how to?
JR
Dweller in the cellar
--------------------------------------------------------------
Home Page: http://www.seanet.com/~jasonrnorth
If you're not the lead dog, the view never changes
Doubt yourself, and the real world will eat you alive
The world doesn't revolve around you, it revolves around me
No skeletons in the closet; just decomposing corpses
--------------------------------------------------------------
Dependence is Vulnerability:
--------------------------------------------------------------
"Open the Pod Bay Doors please, Hal"
"I'm sorry, Dave, I'm afraid I can't do that.."