On Tue, 19 Aug 2008 15:01:29 -0500, Randy penned the following well
considered thoughts to the readers of rec.crafts.metalworking:

I machined two tapered guide strips fron Delrin plastic. they taper
fron 3/4 inch down to 1/8 inch. the ends now bow up. I did machine
all four sides to get them to size first. How do I get rid of the
bow? heat?

1-1/4 wide tapered over 10 inches. 15" OAL.



Thank You,
Randy

Remove 333 from email address to reply.

I don't know where you are .... you could use some 1:1 help. Some of
the responses yo have received are nuts. Email, if interested....
--

Homepage
http://pamandgene.idleplay.net/MachineShop/index.htm