Shaping rubber and rubber balls.
In message , Andy Wade
writes
T i m wrote:
I tried putting it in the lathe earlier but it's just too unstable to
be reliable (and I've images of it flying across the workshop, never
to be seen again) :-(
The trick for machining rubber is to cool it down to about -50 deg C
first (then work quickly). I've seen this done and it's very
effective, but the trouble is that a small workpiece like yours will
probably warm up too quickly for the technique to be useful.
Freezer spray or a Peltier cooler module from RS will get you down to
somewhere near the target temperature.
And what's wrong with a british summer ?
--
geoff
|