On Mon, 18 Aug 2008 15:44:29 +1000, Franc Zabkar
put finger to keyboard and composed:

Here it is:
http://www.eserviceinfo.com/download.php?fileid=37140

Page 25 appears to be the relevant section.

It appears that the protection circuitry is in two parts. Q551 and
Q651 sense the current in the emitter resistors, whereas Q552 and Q553
sense the DC offset at the amplifier outputs. Both protection circuits
trigger the Protect signal at pin 24 of the LM6405G microprocessor via
Q554, and the uP then trips the relay via pin 30.

Disconnecting R556 will disable the DC offset protection, and
disconnecting R553 and R653 will disable the current overload
protection on the left and right channels, respectively. Disconnecting
each of the three resistors one at a time may help narrow down the
source of the problem.

By my reckoning, you would need a DC offset of 2.7V before Q552 would
turn on, and you would need 1.2A in the emitter circuit of Q552 and
Q553 in order for Q551 to turn on. The latter is much higher than your
out-of-spec 60mA idling current.

- Franc Zabkar
--
Please remove one 'i' from my address when replying by email.