Frank wrote in message
. ..

"SteveB" toquerville@zionvistas wrote in message
...

"Mike Dobony" wrote in message
...
I have used Bosh and DeWalt SDS bits and am having problems with both. I
am using 5/32 for tapcons and they dull fast or break. the Bosh seem a
little better, but not what they should be. Are there any quality
alternatives to these two brands?

Mike D.

Do they make SDS that small? The SDS I have have approximately a 3/8"
shank.

Steve


http://www.amazon.com/s/ref=nb_ss_hi...2F32&x=19&y=17



Guess so. Dang. That's quite a neck down. My SDS is on a Makita
Rotohammer, and I have bits up to 1.5". Chisel points, etc. I just had a
hard time imagining that being used for a Tapcon. I'd just use a small
hammer drill for a tapcon. If you snap one off, it surely has to cost less
than an SDS of the same diameter. (?)

Steve