Make one with some scrap plywood and, if you want to get fancy, some
Fastrack parts. Make your fence out of hardwood and 90 degree aluminum angle
iron from the borg. Mine cost me less than $20 and a relaxed Sunday morning.

I find that I seldom use the Fastrac slots and hold downs I built into mine,
but I do use the fence a great deal.

Tip: If you use a drill press vice very often as I do, for sharpening
mortising bits in my case, be sure to cut the same slots in the new table
that you have in the old table.

--
www.e-woodshop.net
Last update: 8/16/03


"Jim" wrote in message
I would like something easier to clamp wood to than the cast iorn
table of my drill press. Would a FastTrack drill press table and
fence be a good idea?
Thanks