On Jul 2, 3:35 pm, alphamnemonic wrote:
Hi Everybody

This chip normally puts out square pulses. In the power supply I am
working on (http://www.laserfaq.org/sam/150rcsch.pdf) it is putting
out a sawtooth wave. I am testing it in 'standby mode', in which Q4 is
off and R33 is in control of the duty cycle. Replacing the IC1 has no
effect. Does anyone have any ideas?

Where are you seeing sawtooths? Pin 13?

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header
above is
ignored unless my full name AND either lasers or electronics is
included in the
subject line. Or, you can contact me via the Feedback Form in the
FAQs.