Thread: Tub refinishing
View Single Post
  #5   Report Post  
Posted to alt.home.repair
evodawg evodawg is offline
external usenet poster
 
Posts: 272
Default Tub refinishing

Charles Bishop wrote:

In article
,
wrote:

On Jun 26, 12:54=A0pm, (Charles Bishop) wrote:
I have a customer who wants his tub "touched up" after I removed a
slidin=

g
shower door. The top edge of the tub where the shower door was shows
some cracking, and pieces 1/16" inch chipped off.

Is there a decent way to repair these? At Home Depot I saw some spray on
epoxy repair, some brush on repair but don't know which might be best.
As just a guess, I'd sand down the area, remove any chips, fill with
some sort of epoxy filler, sand again, prime and then spray on the
epoxy. It might be close enough in color that I'd only have to do the
repaired area and not have to do the rest of the tub.

Does this sound doable? If so, what to use as the expoxy filler? Any
othe=

r
suggestions?

Thanks,

charles


I have used the brush on with good results. Frankly I think I
would have better luck with the bush unless I had a lot of experience
with the spray stuff.



Did it look smooth when you were done? Can you sand it and put on another
coat? What can be done about chips 1/16" depth, about the size of a
quarter or nickle?

I've seen guys spray something like this on tubs with good looking results
but not sure how long it lasts. Think they used one of those HVLP guns and
compressor. He also used the same product (different color) to do a kitchen
counter top. Think you might have to do the whole tub though.
--
"You can lead them to LINUX
but you can't make them THINK"
Running Mandriva release 2008.0 free-i586 using KDE on i586