On Sun, 29 Jun 2008 00:22:17 -0400, "Flash"
wrote:
snip
I think that would get your job done right.

I have used the dead-center point in the back of the standard tee-handle
tap-holder method, with decent results.
snip
====for current production see ====
http://www.use-enco.com/CGI/INPDFF?P...MITEM=318-0150
most mill supplies should have something similar in stock.



Unka' George [George McDuffee]
-------------------------------------------
He that will not apply new remedies,
must expect new evils:
for Time is the greatest innovator: and
if Time, of course, alter things to the worse,
and wisdom and counsel shall not alter them to the better,
what shall be the end?

Francis Bacon (1561-1626), English philosopher, essayist, statesman.
Essays, "Of Innovations" (1597-1625).