Sketchup is nifty!
"Swingman" wrote in message
...
"Jack Stein" wrote
Seems to me when specifying a hole size, you would also specify r for
radius or d for diameter.
Any one else chiming in to quibble for the sake of quibbling should
contemplate the following BEFORE they open their mouths and let their
inner
idiot out:
POSTED WAS A JPG FILE RENDERED FROM A 3D DRAWING!
POSTED WAS A CAD FILE!
THE POSTED JPG P*I *C*T*U*R*E IS *NOT* A MEASURED DRAWING TO BUILD FROM!
(download the CAD file, and READ the actual drawing if you want to do
that,
the DIFFERENCE between a "radius" and "diameter" dimension on this CAD
DRAWING is OBVIOUS, providing you take the time to LOOK *before* you open
your mouth's to quibble!)
BEING A RENDERED PICTURE FROM A 3D DRAWING, DO NOT BUILD FROM IT!
BEING A RENDERED PICTURE FROM A 3D DRAWING, DO NOT BASE A "DIMENSION"
ARGUMENT ON IT, YOU WILL LOOK A FOOL!
THIS IS A RENDERED JPG FROM A 3D DRAWING, SO DON'T MAKE ANYTHING FROM IT!
THE POSTED P*I *C*T*U*R*E IS *NOT* A MEASURED DRAWING TO BUILD FROM!
IF YOU DO ATTEMPT TO BUILD FROM THIS PICTURE YOU ARE AN IDIOT. IF YOU WANT
TO BASE AN ARGUMENT ON THIS JPG RENDERING OF A 3D CAD DRAWING, YOU ARE A
BIGGER IDIOT.
IF YOU CAN'T TELL THE DIFFERENCE BETWEEN A "RADIUS" AND "DIAMETER" ON THE
ACTUAL CAD DRAWING, STFU AND LEARN TO *READ* A DRAWING BEFORE YOU SPOUT
OFF!
Anyone else! ... if so, politely go **** yourself in advance!
Uhhhh...., Swingman, I wasn't gonna quibble or argue drafting/CAD
conventions.
But with that rant you just posted, I do feel an uncontrollable urge to
poke you with a pointy stick. Soooo...., forgive me.
Poke, Poke
G
|