On Jun 7, 4:12*pm, ransley wrote:
On Jun 7, 1:28*pm, badaddidude wrote:





I have bypassed the lid switch and drained the water (even though it
tasted terrible!) (I'll never fart in my underwear again!)
The machine agitates but the motor only hums when it is time to drain
or spin. I cannot see what actuates either the pump or spin modes. Is
it internal to the motor?

On Jun 7, 7:38*am, Mikepier wrote:

The problem with this washing machine failure is that you cant work on
the machine until the water is out of it. *You cant pull a full
machine away from the wall, it's too heavy. *Thats where the nasty
part comes in. *

If it's like most top loaders, you don't need to pull it from the
wall. The front panel can be easily removed by sticking a putty knife
on *each side *between the top of the front panel and the top panel to
release the tabs. Then lift the front panel off the bottom pegs and
you should have access to the pump.- Hide quoted text -

- Show quoted text -

My door switch broke but to complete the circuit I had to connect the
wires together, just disconnecting the switch may not give power.- Hide quoted text -

- Show quoted text -
Does this machine reverse the motor polarity/direction to go from
agitate to pump out and spin??? I am pretty sure that the Maytag
family of machines do this, but i have not worked on Whirlpool family
of machines for several years.