"The Medway Handyman" wrote in message
...


Thomarse wrote:
Hi,

I need to drill into my new ceramic wall tiles in my bathroom to
install a shelf etc. Would you recomend using specific tile drill
bits, which are the spear point type or can I get away with using
standard masonry drill bit?

Use one of these Bosch Multi Material bits
http://www.screwfix.com/prods/26900/...-Bit-6-x-100mm

They have a much sharper point than a standard masonry bit. With the
drill off, push the bit onto the mark where the hole will be - push hard &
you will hear a 'creak' noise as the point penetrates the surface. No
need for tape, the bit won't now wander.

Drill with hammer off until you go through the tile, then switch the
hammer on if necessary.


--
Dave - The Medway Handyman
www.medwayhandyman.co.uk



I have just bought one of these on you recommendation MHM. I also got the
two sets of rawplugs to try them both. I too am putting up a pull out mirror
tomorrow and drilling through the tiles. Is it best to try to go through the
grout? Will use the bosch multi purpose drill bit you recommended to me on
the plasterboard screw thread.