Here is what you do.
Get ahold of a big ass hammer and wail the tar out of it for half an hour.
It will look used, useful, and you will never know the difference.
Shoot for a heart rate of 80 or so.

"Ignoramus9931" wrote in message
...
Related to my yesterday's vise refurbishing project, where I milled a
little thin layer off the anvil to make it look smooth. I used a 5/8"
carbide endmill. I made multiple passes, each time removing a "strip"
approximately 1/2" wide.

While the result is perfectly acceptable for a vise anvil, it was
nothing to brag about as far as finish quality is concerned.

Here's one revealing pictu


http://igor.chudov.com/projects/misc...-Vise/Repainti
ng-Of-Wilton-500S-Vise-2182.jpg

The ridges you see, are visually exaggerated by the fact that some
passes fere from left to right and some were from right to left. They
look bigger than they are because of this. In reality they are not
really that high.

So. What would you do, to achieve a decent looking flat finish,
without a surface grinder or anything of the sort.

--
Due to extreme spam originating from Google Groups, and their
inattention
to spammers, I and many others block all articles originating
from Google Groups. If you want your postings to be seen by
more readers you will need to find a different means of
posting on Usenet.
http://improve-usenet.org/