View Single Post
  #3   Report Post  
Posted to alt.home.repair
[email protected] trader4@optonline.net is offline
external usenet poster
 
Posts: 4,500
Default Similar Basement Seep Question

On May 17, 10:13*am, "DanG" wrote:
The best waterproofing is always done from the outside. * *Pipe
penetrations are hard to seal when done right, I imagine they have
two lines coming through one hole - it would have been easier to
work with two holes with one line. *Dig it up on the outside, be
careful around the copper line set, Get generous with the hole so
you can really clean the wall where the lines are going through.
Use plastic roof cement and reinforcing cloth, be generous and
thorough, and cover the fresh tar with a shield of card board,
Styrofoam, or other sheathing to keep the dirt from rubbing
through the tar when you put it back in. *Leave the protector
board.

The dark color under the line set says the concrete is still
saturated. *You might also look up Xypex.

--



I'd add that some type of window well cover is also a good idea.
Even if it's not complete because of the oil line, etc, covering up
say 90% will keep a considerable amount of water out.






______________________________
Keep the whole world singing . . . .
DanG *(remove the sevens)


"Dimitrios Paskoudniakis" wrote in
messagenews:8fmdnXFNUJxLf7PVnZ2dnUVZ_rjinZ2d@comca st.com...



We had 5" of rain, and near one corner of my house with all
in-ground basement, there is a window with outside window well,
with stones at the bottom. Just to the left of the edge of the
window well in the basement is a penetration into the basement
of the lines from the outdoor A/C. *Just under that there was a
little seepage, which ran in a vertical line a couple of feet
down the basement wall, then stopped. *The basement wall is
poured concrete.


What is the best approach to prevent a recurrence? *Should I
cover the window well with a plastic bubble cover? *I have an
oil tank in the basement and the lines for the oil are too close
to the window well *to install a standard plastic bubble, and I
also have an electric line to attach a gas-powered generator to
an electric panel in the basement, that also blocks a standard
plastic window bubble cover.


What about caulk under the A/C line penetration in the basement,
or dry-lok paint? *Any other ideas?


Finally, what does it mean that the wet area on the basement
wall still is visible days after the rain stopped?- Hide quoted text -


- Show quoted text -