Conundrum..

Ouch! GOOD LUCK!

And just think, folks make fun, now days, of people with CRT based
sets. At least you've got a chance repairing them relative to what
you're contemplating going through!

I'll believe I'll stick to my free 25" stereo (CRT) TV set that was
given to me with a vertical oscillator/amplifier & a few electrolytics
that needed replacing.. While it certainly won't look as impressive as
a new plasma based set, it's certainly not as expensive and sure
significantly less work and cheaper to repair. In addition, probably
doesn't cause quite as much RFI as most plasma sets tend to do!

Cheers,
Mr. Mentor


"conundrum" wrote in message
...
| Hi all.
|
| I have two of these beasties, both JVC 42" plasmas made at about the
| same time.
|
| Unfortunately, one has a burned out PDP (has big black line on the
| screen about 1/3 the way across and halfway down the screen) and the
| other has an apparently fried controller board but the PDP looks
fine.
|
| I've got as far as determining that the base boards are not
| mechanically compatible but they do use the same PDP, with
essentially
| the same pinout and specifications.
|
| I can't seem to work out how to separate the PDP and uber-fragile
| flexi cables with embedded LSI HV chips from the base plate with its
| incorrect screw locations, undid about 24 screws and no go
|
| Has anyone even attempted such a mammoth task? It seems feasible
(the
| LCD I modded is easy by comparison)
|
| Thanks in advance.
| -A
|
| "Bother" said Pooh, as Darth Maul 'sabred him in twain...