How'd you like to be a fly on the wall when someone in a wood-starved future
tried to saw the stuff apart?

"PC" wrote in message
...
The only caution is that cedar is soft. Kitchen cabinets get used
heavily and will show the wear perhaps quicker than you'd like. I don't
see that anything other than glue is needed if the boards are edge
jointed first. Four inch boards don't need biscuits. Glue, clamp and
plane.

Phil

Jerry Hobson wrote:
I was talking who does nice work around his house with pine and cedar.
He edge
joins a lot of material, it's all over his house.
Not master craftsman work but not bad looking stuff.
I've decided to make kitchen cabinets in my basement suite out of 1 inch
cedar.
I have a lot of nice 4 inch wide stuff.

So I asked him what joinery method he recommended expecting him to say
biscuits,
or dowels.
He uses small ring nails. He cuts the heads off adds his glue and then
forces
the boards together with clamps. He has fancy clamps that apply pressure
to all
four sides of his boards at once.
He says this work just as good as biscuits or dowels.

The question I have, is he right?
It seems like an easy and cheap method for joining boards if you keep
them under
planner width.