"S. Barker" wrote in
:

Once you get your 2x in there and get it supported, then take the belt
sander to finish off any unevenness. A pad and carpet is very
forgiving. You should be ok without the underlayment.

s



"Red Green" wrote in message
...
Have a hall where there is unevenness under carpet down part of the
length.
There will be new carpet going down eventually. Found that the
subfloor has
a joint that is not on a joist. About an inch away. T&G but it's
obviously been ignored many years. Tongue is broken in some areas.

I plan to put some 2x' from underneath with the face across the joint
and screw the subfloor to it from the top to get the two sides even
(I hope). Then support that 2x with a 2x that is sistered to that
nearby joist. Hoping I can get it pretty even but being in such a
conspicuous place, I think ideally a piece of say luan should go over
the floor before the pad and carpet go down.

This would be fine except that the hallway runs open into the LR
area. Wherever that luan ends a new unevenness is gonna be created I
believe.

Maybe I am overthinking this and once I fasten both sides of the
joint solid, the pad and carpet will consume any slight offset.

Opinions and/or ideas?





Yep...part of the plan.