On Tue, 6 May 2008 05:50:38 -0500, "Karl Townsend"
wrote:


I think I know of one in California..Anaheim

Even more of a road trip.

http://www.mcleanlathe.com/

Ask for Joe or Mike, tell him Gunner the OmniTurn guy referred you.

Thats a BIG freaking mill. Even I nearly need a stepladder to run it.

You should see one make chips. Do you know, for sure, of the condition of
this unit? There's an FTV-4 on eBay, reliable tool, right now. looks like
they did a super job cleaning a beater. I almost contacted you for an
inspection of that unit.

I shook hands with a fella to buy my Bridgeport just as soon as I get a
replacement mill. Plus, my son is laid off right now. I'm buying gas to
anywhere in the good old US of A to pick up a nice FTV-4.

Karl

Im not sure, for sure, but it was under power when I was in there
last. No one wanted to use it, because they are all short latinos, and
needed to stand on a box to run it.

Give em a call and see what they say

Gunner

Political Correctness is a doctrine fostered by a delusional,
illogical liberal minority, and rabidly promoted by an
unscrupulous mainstream media, which holds forth the
proposition that it is entirely possible to pick up a turd by the clean end.