Searcher7 wrote:
On May 4, 8:06 pm, Wes wrote:
wrote:
I am looking into a tool that will allow me to bend 6" X 24"(1/8"
thick) mild steel lengthwise.
That is a pretty hefty bend. How many of these do you need? What is the
inner radius?

Wes

Oops! I forgot to ask about that.

Ok, this would not be a sharp bend, but the curve on the *outside*
would be the same as that of a 2inch ball(max.).

I'm assuming that the radius would be 1 inch and a tiny bit smaller
since the metal would only be 1/8" thick.

Also, how much easier would 72 degrees be?

What you now describe would be a piece of cake for a hossfeld type
bender if it was 4" wide and bending in the small direction, 6" is too
wide for the hossfeld, but you might copy the basic form in a purpose
built bender, if you are bending the 24" way some form of press brake is
about your best shot. Or cut a section out of a piece of 2" x 1/8" wall
tubing and weld it to a pair of plates.