On May 4, 8:06*pm, Wes wrote:
wrote:
I am looking into a tool that will allow me to bend 6" X 24"(1/8"
thick) mild steel lengthwise.

That is a pretty hefty bend. *How many of these do you need? *What is the
inner radius?

Wes

Oops! I forgot to ask about that.

Ok, this would not be a sharp bend, but the curve on the *outside*
would be the same as that of a 2inch ball(max.).

I'm assuming that the radius would be 1 inch and a tiny bit smaller
since the metal would only be 1/8" thick.

Also, how much easier would 72 degrees be?

Thanks a lot.

Darren Harris
Staten Island, New York.