View Single Post
  #3   Report Post  
Posted to alt.home.repair
Red Green Red Green is offline
external usenet poster
 
Posts: 4,946
Default Install Roof Turbine w/o Cutting New Hole

jay wrote in news:25b38533-8c75-45a0-a72e-
:

I have wanted to install a roof turbine to vent the attic of my house
for many years but kept deciding against it due to the possibility of
water leaks. Could I instead place a roof turbine on top of an
existing vent and cut a hole in the corresponding vent in the attic?
There is a kitchen vent (with squarish metal cover) and a toilet vent
(3" or 4" PVC pipe, open top). Also my roof has a 45 degree pitch.
Would I be able to use Lowe's roof turbine which has dual (upper and
lower) bearings or would I be limited to HomeDepot's which only has
upper bearings in order to clear the existing protrusion from roof? Thx


You are a lot more likely to have a leak trying to hack & jimmy-rig it the
way you describe. This might even make a good clip for the Red Green show.

By the time you finish the initial install and patch the inevitable leaks
with roofing cement (don't care what it looks like as long as it doesn't
leak any more) it will be fugly. The vibration of turning will surly create
(more) leaks. They are meant to be nailed down to the sheathing, and
integrated with the shingles if they are installed like regular vents.
Gonna nail it to the the existing vent are ya? Ahhh, drywall screws! How
about a good windstorm and that thing starts whipping around. It'll take
off like a helicopter. Now you still have an open hole in the roof and some
splainin' to do the the neighbor with the broken windshield.

45 degree pitch?! You planning on going up on that 12/12 roof with just
sneakers? You will need roofing jacks which means you have to pop up the
tabs of some existing shingles, slip the jacks under and screw them into
the roof. Ahh, you're gonna try it without the jacks because you are afraid
the screw holes will leak later.

As far as the different Borg turbines, you need to look at the mfgrs
instructions/specs for the particular turbines they have.

And BTW, what air is it going to pull out if it's over a vent? Maybe where
ever the vent is venting - the kitchen ya think? Wifey will be at the stove
under the vent, turbine spinning in a wind and her hair will look like Don
King. The turbine is suppose to be pulling attic air.

Based on what you are proposing and how you are considering doing it I
highly suggest you abandon doing this...in any manner yourself.