hi guys

anybody tried pressing in 'off the shelf' bronze bushings into the ends
of DOM steel tube?

or does anybody know what the typical ID (and OD) tolerances of DOM
steel tube are? I need some that hopefully has a 1.375 OD (OD not real
critical) and an ID that's as close to 1.125 as possible (I need to
press-fit 1.000 ID bushings into each end). not wanting to 'hire out'
lathe work or honing for this fitup, if possible...

I can 'move up' to 1.500 OD, if it'd help the ID tolerance closeness any
(but I kinda doubt it would)

thanks for your real-world experience and sharing the info :-)

toolie

- -
replies to this post by e-mail, if any, please remove the weirdstuff
from my address before clicking 'send' - thanks :-)
- -