"Gareth Magennis" writes:

"Bennett Price" ""bjpriceNOSPAM\"@NOSPAMcal berkeley.edu" wrote in message
...
I've got a small 12V DC .9 Watt 'muffin' fan (1.75"x1.75"x3/8").
It was the cooler for a video card's processor chip and was
frozen up.

I put a drop of oil into its sleeve bearing and it now runs
reliably - almost. It will start every time as long as it is
not oriented with the open 'face' down. (The open face is the
side in which you can see the bearing). If the open bearing is
down, it sometimes starts and sometimes needs a slight nudge to
get it going.

What's going on? How come? TIA

Presumably because the bearings are worn out. Get another one.

I've disassembled these, cleaned, and relubed with decent success.

But a new fan is not expensive.

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.