View Single Post
  #19   Report Post  
Posted to alt.home.repair
ransley ransley is offline
external usenet poster
 
Posts: 4,926
Default Briggs & Stratton Engine Problem

On Apr 16, 9:30*pm, Manjo wrote:
I have a leaf blower that uses a 5 hp B&S "L" head engine. *The carb
is pretty simple with a choke butterfly, throttle butterfly, and
rubber diaphragm fuel pump. *The carb sits on top of the fule tank.
The carb has no bowl. *The governor linakges are clean and the
governor appears to be working fine.

The leaf blower was starting to run poorly last fall. *This spring it
started right up, but after4-5 seconds after running smoothly at
proper speed, it will slowly loose rpms and finally stop after 15-20
seconds.

I have cleaned the pick-up tube, replaced the carburetor diaphragm
fuel pump along with the gaskets between the carb and the fuel tank,
and the gasket between the carb and the engine. *I've also
disconnected the engine ground wire that normally kills the engine
when the throttle is tuned full off. *But after doing all this the
engine still will not stay running for more than 30 - 40 seconds.

Thanks in advance for any tips, suggestions, or coments.

Manjo


It probably has an electronic ignition mobule, see if it gets spark
just after dying, if its very old with points maybe a capacitor is bad