On Fri, 18 Apr 2008 07:46:39 UTC, "Franko"
wrote:

I can't help as much as I would like as it was a while ago but I had a Bosch
dishwasher replaced on insurance with a Siemens model. this was basically
the same apart from some cosmetic differences but all the innards looked
identical.
The fitter damaged the drain hose on the new one whilst fitting and then did
a runner leaving me with a wet floor so I took off the side panels of old &
new machines and realised that I could swap the hoses as they were the same.
I don't remember exactly how it fitted but I am sure that it was just a
pushfit with an O ring and a slight collar on the hose that stopped it
popping out under pressure. It took about 10 minutes if I remember
correctly.

Thanks, Bob; that's useful (and reassuring!).

--
The information contained in this post is copyright the
poster, and specifically may not be published in, or used by
http://www.diybanter.com