"DerbyDad03" wrote in message
...
On Mar 29, 2:51 pm, "Edwin Pawlowski" wrote:
"DerbyDad03" wrote in message

If you lift the front edge of the board slightly, you can easily
complete the cut on a 2 x 6 on a saw that only claims a DOC of 5 3/8".
Make your cut with the board flat, then just tilt the board up enough
so that a few more teeth on the front of the blade complete the cut.

I do it all the time with my Delta 10" non-slider.

******************************

I can see nasty repercussions if not done properly though.

That statement applies to the use of *so* many power tools as well as
*so* many other situations in our daily lives.

BTW...after I posted my method, I was watching one of the multitudes
of "home" shows on TV and so one the supposed experts apply the same
technique.

*****************************

That may be true, but I'm still not going to advise someone that may have
never used a power saw to turn the board while the blade is spinning at high
rpm.