DIYbanter - View Single Post

SteveB[_5_]

"James" no wrote in message
...
I want to mount a PT 2 x 4 to a cinder block wall in my basement, in
order to build some shelves.

What is the best way to do this ? These shelves may hold a max of 100
lbs.

I have seen those lead "sleeves" which I suppose you screw lag bolts into.
Is that the best method ?

Are there other products which are easier to use ?

I do have some mortor bits, so I am guessing that I can drill into this
wall ok. I don't think it is poured solid at this place in the wall.

Thanks for any tips.

James

I answered TapCons because you said it was solid concrete. In that case,
TapCons would be the thing. BUT, if you have grouted cinderblock, use
sleeve anchors. These are anchors that hold in soft masonry such as
cinderblock and grouted cinderblock. Just look for the particular fastener
labeled "sleeve anchor" and allow for the thickness of the board, and 2"
penetration into the block, which would be 4" for a good fastener.

Steve