On Feb 21, 2:18*pm, "Dave" wrote:
"David Farber" wrote in message

...



Did you go into the source menu of your receiver and check that the audio
is
set for HDMI? You can also try a separate coax or optical cable from your
Blu-Ray player to your receiver and see if the audio works that way. (Of
course, you'll need to make the appropriate change in the audio select
menu
if you change it.)

Here's a good question: *did it EVER work? *I mean, did it work fine one day
and not the next? *If it's never worked I'd definitely go through the setup
procedure at the beginning of the manual, there are lots of settings in
there that could make it non-functional for one reason or another. *The fact
that you're getting no error codes strongly indicates that it's not broken,
just perhaps set up wrong.

Dave

Dave,I messed with it again last night and i noticed a click about 2
sec. after i turned it on. So, it might be going into safe mode
but, i still haven't seen any error code. I bought the receiver like
this. I figured it was something minor but ,i m not a tech either.
I didn't pay that much for it so i can put alittle into it . Suggested
retail for this receiver is $1599.00