Thread: End Milling Into a Corner Without 'Snipe'?
View Single Post
  #5   Report Post  
Posted to rec.crafts.metalworking
Mark Rand Mark Rand is offline
external usenet poster
  
Posts: 852
Default End Milling Into a Corner Without 'Snipe'?
On Mon, 18 Feb 2008 03:25:57 GMT, (Doug White) wrote:



Any suggestions or tricks?

Thanks!

Doug White


Use a slot drill (two flute centre cutting cutter) if you really must avoid
the digging in. It will protect you because the front flute will be clear of
the cut before the back flute is close enough to risk digging in.


Mark Rand
RTFM
Reply With QuoteReply With Quote