"oldjag" wrote in
message
...
I'm trying to turn down a 3/4" x 26" long
4140 shaft to a diameter
of 0.669" +/- 0.0005" (17mm). Does anyone
have a design or source
for a follow rest that attaches to or near an
Aloris CXA tool post?
The normal follow rest that came with the
lathe would be hopeless due
to the offset relative to the tool point.
I'm hoping to get within a
2-4 thou and then grind to the final diameter
with a Dumore tool post
grinder. Does this seem like a possible
scenario?

Just another possibility----

A 3 ft chunk of 17mm oil hardening drill rod is
less that $20. If it would work, that
eliminates the turning part of the job and maybe
even the grinding part, depending
on what you need.