a choice: unisaw w/ unifence vs unisaw w/ beis
On Wed, 30 Jan 2008 14:15:05 -0700, "Kevin"
wrote:
What about drilling 5 or 6 1/4" holes in the fence for afixing sacrificial
fences, etc?
That's what I did on the second fence.
I was thinking to do that with my Bies also, but never got around to it. I
was going to imbed inserts.
Is there for certain a flat on the backside of the Uni? That's important,
or I guess at least enough room for a 1/4" washer to span.
1-3/8" approx. for the whole length.
I'm gonna try to find a Uni to look at.
"Frank Boettcher" wrote in message
.. .
On Wed, 30 Jan 2008 10:26:42 -0600, dicko
wrote:
On Wed, 30 Jan 2008 08:53:56 -0600, Frank Boettcher
wrote:
snip
Biesmeyer is ...... A little easier to attach feather boards, space
blocks and temporary sacrificial faces to the Biesemeyer.
snip
So just how do you attach feather boards, spaceblocks, and sacrificial
faces to a Unifence?
I have a Unifence and thats the most exasperating thing about it. Its
got that damned curved backside that prevents you from clamping
anything to it.
-dickm
I have to admit to having an extra fence where I have permantly
attached a wooden face that has cuts for a dado and molding
cutterhead. Slide the primary off and this one on.
I have a set of griptite magnetic featherboards and holdowns and have
installed the supplied steel plate to my primary fence, resetting the
face to the scale.
There is a flat on the extrusion that will take a block and provide a
good clamp surface. A little trouble but works fine.
Frank
|