Thread
:
Drilling hole down a curtain pole
View Single Post
#
7
Posted to uk.d-i-y
LSR
external usenet poster
Posts: 129
Drilling hole down a curtain pole
wrote:
On 24 Jan, 10:33, Ian Chard wrote:
Hi,
I'm about to put up a curtain pole, but the size I wanted wasn't
available, and the one I have is quite a bit too long. It has
pre-drilled holes down either end into which the finials screw.
The instructions say to cut it square and re-drill the hole. How do I
go about drilling into the pole making sure the hole is parallel? I
don't have a lathe
I've done this - I just went by eye - possibly more accurate if you
use someone else's eyes as well. From memory being out by a few
degrees shouldn't matter, though it will depend on the pole and the
finials.
Edward
Tape a 2ft length of 1/4" dowell to the top of the drill so it's parallel
with the drill bit and clears the curtain pole. That should make it easier
to align the drillbit by eye.
--
LSR
Reply With Quote
LSR
View Public Profile
Find all posts by LSR