Hi,

I'm about to put up a curtain pole, but the size I wanted wasn't
available, and the one I have is quite a bit too long. It has
pre-drilled holes down either end into which the finials screw.

The instructions say to cut it square and re-drill the hole. How do I
go about drilling into the pole making sure the hole is parallel? I
don't have a lathe

Thanks
- Ian

--
Ian Chard, Senior Unix and Network Gorilla | E:
Systems and Electronic Resources Service | T: 80587 / (01865) 280587
Oxford University Library Services | F: (01865) 242287