View Single Post
  #29   Report Post  
Posted to sci.electronics.repair
CJT CJT is offline
external usenet poster
 
Posts: 1,155
Default Electric dryer - thermal fuse question

Rick wrote:

William Sommerwerck wrote:

"Rick" wrote in message
...


Set the meter to AC 750V range. Closed the breaker. Tested
black to neutral: no reading. Tested red to neutral: In a split
second "FFFZZZZ!" and the wire inside the insulated test lead
fried and shot out of the test probe.




Non-sequitur. It sounds as if you had the probes inserted in the current
jacks.



Nope. I checked it twice before testing. And since it was brought up I
looked at the meter again - correct jacks.


Was it set to read voltage or current? Likely current.


Your reasoning wouldn't explain why it didn't 'zap' when testing the
first 120v side of the 240v receptacle. I got no reading at all on the
white and black side. (No fried test lead either.) It went 'zap' when I
tested the white and red side.

Rick



--
The e-mail address in our reply-to line is reversed in an attempt to
minimize spam. Our true address is of the form .