Robert your method works quite well, but I have changed to using a
Topcon lead bit (because I own them), sliding in a piece of #12
copper with the insulation left on ( I cut up a bunch them and
keep them in the hammer drill box), drive in a 16d duplex or screw
in a drywall/deck screw. You'll need a 3 or 4 foot crowbar to
pull the nails.

--
______________________________
Keep the whole world singing . . . .
DanG (remove the sevens)




"Robert Allison" wrote in message
news:jz7hj.17251$Xo1.4153@trnddc06...
HerHusband wrote:

I need to install a new basement door at my in-laws house,
which will require new concrete to be poured under the door
sill. The original foundation was notched out lower, then
someone later poured a slab outside, so the opening under the
door is a real mess.

My plan is to take down the current stairs, and attach a 2'x4'
piece of plywood to the existing concrete wall as a form so I
can pour in more concrete. Shouldn't take more than 4-6 bags of
concrete. I'm planning on drilling into each side of the
opening and adding a few pieces of rebar to tie everything
together.

However, I'm wondering what the best and easiest way to attach
the plywood form to the existing foundation would be. I was
planning on drilling holes and using masonry anchor bolts, but
I don't really want the bolts to be permanent. I've never used
Tapcon screws before. Would they be strong enough to hold the
pressure of the concrete, and are they removeable once
installed?

Thanks,

Anthony

One way to do this with the least hassle and less money is this
method:

Drill a 1/4" hole through a 2x4 every 12" or so, the same
heighth as your side form. Place the 2x4 against the wall so
that your plywood form can be nailed to it to form the side.
With a masonry bit and a hammer drill, drill a hole into the
concrete through the top hole in the 2x4. Drive 2 16 penny
common nails through the hole into the concrete. Repeat through
every hole in the 2x4. Attach your plywood form to the 2x4.
(You can attach the side form to the 2x4 first if you wish, but
sometimes that makes it more difficult to level the form.

When removing, pry the 2x4 and side form off the wall as a unit.
The nails usually pull through the 2x and will have to be
removed from the wall. You will probably not believe how well
this works. I usually break the nails trying to pull them out.
Try it first, if you don't believe me.

--
Robert Allison Rimshot, Inc.
Georgetown, TX