Bill wrote:

After using a lot of hot water, the pipes have run dry. There was a
gurgle and then a hiss like air being sucked in - then the hot water
went off.

The hot tap works in the kitchen downstairs, it's just the bathroom
taps that don't.

I left them alone for an hour or two then turned the sink tap on
again. There was a weak flow of water then it went off. Same with the
bath.

I don't have a hosepipe to try the trick of forcing water up from the
kitchen cold tap, nor do I have any plumber's tools.

Any suggestions, other than call a plumber?

Since nobody else has mentioned it if you have a mixer on the bath then
you simply hold your hand over the spout and turn both h&C on full and
keep holding for about a minute. Release your hand turn off the cold and
the hot should splutter to full flow.





--
Ed Sirett - Property maintainer and registered gas fitter.
The FAQ for uk.diy is at www.diyfaq.org.uk
Gas fitting FAQ http://www.makewrite.demon.co.uk/GasFitting.html
Sealed CH FAQ http://www.makewrite.demon.co.uk/SealedCH.html