Tim Jenkins wrote in message
...
Hello,

I'm thinking of building a closeboard fence to divide the front garden
from
the side garden and I need to put a gate somewhere along the run.

I was planning on using Slotted conrete posts, gravel boards etc - but how
do you fasten a wooden gate to a conrete post ???

Cheers in advance,
Tim.


Attack the post with a masonary drill. Affix the gate timbers using normal
Plasplugs and screws etc.
The big problem is not allowing the drill to hit the steel (usually 1/4")
reinforcing wires that run through the post from top to bottom. There's
usually about 4 of them spaced equally.
Best to try drilling a test hole or two, to make sure you're to one side of
the rebars.
Aim towards the centre of the post, to avoid the concrete 'spalling' if
screwing too near to the edge.
regards
john