wrote in message
...
I want to put a potbelly stove in my basement. Preferably on the wall
that doesn't have a window on it. How hard of an install, and what
procedures would there be?

Good grief, man. How would we even guess? If you were any more vague, your
post would be just blank.

First things first.

Find out if you need a permit. Nothing like getting red tagged in the
middle of it, or having to rip it out and do it again.

Check with your insurance company. Your rates will probably go up. Mine
almost doubled for homeowner's.

After that, the construction isn't rocket science, but not knowing a thing
about your setup, I can't offer any advice. Components are available from
any fireplace store. Putting them in right and safely is another thing.
Cutting openings, coring concrete, making sure everything's right and safe
is vital. Straight runs of chimney pipe are best, and nineties are bad.
You have to use air to combust wood. What's going to be your air source?
Room air? Outside air through a duct? No sense sending warm room air up
the chimney. You may be better off to just run a 220 and put a heater in
there.

Then there are CO monitors. Get the digital type so you have a displayed
level rather than waiting until it is critical to beep.

You may have to have a hole cut in the wall. You may have to redo framing
and everything up from the stove. You may have to put in fire blocking and
fire resistant materials.

Other than the things mentioned above, it's a snap.

Steve